

€214.83 (tax excl.)
Ledson Pollux9+ strobe with white or orange position light
A high beam with flash, all in one!
Pollux9+ Strobe is a further development of Ledson's immensely popular Pollux9+ Gen 2. In addition to a wide and distant light image with the Driving beam of the reflectors with 480 meters at 1 Lux, it also has selectable position light (white or orange), stable mounting, electronic temperature optimization, Goretex membrane to prevent moisture in the lamps and everything that distinguishes the standard Pollux9+. The Pollux9+ Strobe also has ECE R65 approved strobes. This warning light consists of four powerful LEDs that can be set to five different flashing patterns.
Flash patterns:
Single flash (ECE R65)
Double flash
Triple flash
Quadruple flash
Continuous hyper flash
Specifications:
Five different flash patterns, one of which is ECE R65 approved
Synchronizable
E-marked (E8, ref. 37.5), ECE R112 / R10 / R7 (white position light)
EMC protected (do not disturb the radio)
With position light (4 LEDs) yellow/orange or xenon white (connect the desired color)
Range: 960 m (0.25 lux), 480 m (1 lux)
12000 lumens (theoretical), 9600 lumens (actual)
Cold White Light (6500 K)
Membrane to prevent moisture
36 months warranty
Technical specifications:
120W (12 x 10W Cree XM-L2 LED)
4 LEDS as flash
Rated power 92.4 W
6-pin DT connector (including 2-pin adapter)
Load 7.7 A @ 12 V and 3.6 A @ 24 V
What's in the box:
Pollux9+ Strobe Ledson LED spotlight 9" with Driving Beam and flash function
Bolts and screws for attaching the parking light with one or two mounting points
DT connector (6-pin, supplied with 2-pin adapter)
Red: High beam(+)
Black: High beam/ Position light (- ground)
Gray: Position light (+) white
Yellow: Position light (+) orange
Green: Flash(+)
Blue: flash pattern/synchronization
Flash pattern synchronization: Connect the blue wires of two or more lamps and then briefly connect them to the positive terminal for 3 seconds to reset the flash frequency of all connected lamps, after which all flash patterns will be changed.
Please note: The DT connector must not be cut, as this increases the risk of moisture damage and will void the warranty.
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
Review sent
Your review cannot be sent