LED Position light fog lamp Scania R/S 2016+ - amber

LED Position Light Fog Light Scania R/S 2016+ amber

✓ Additional position light for Scania fog lights (2016+)
✓ Position light for both fog lights
✓ Yellow light

Position light for both left and right fog lamps, two light sources. Specially developed LED light sources with 18 powerful LEDs that fit in original Scania LED fog lights. Thanks to the light sources, which are available in xenon white and yellow, there is always light in the entire reflector of the fog lamp. The light is not blinding and works as a position light. Due to the smart design, the original fog lamp is fully preserved.

The light source is attached to the fog lamp on top of the existing light source. Screws and spacers are included and must be used during assembly. A 3 meter cable is included.

Fits Scania 2016 and newer models (Next Generation)

Edit
Remove all five screws on top of the lamp.

The heat sink glued to the lamp should be carefully cut along the outside edge with a hobby knife. Look at the picture on the top of the heat sink, it is marked with a red dotted line where you will be cutting. Break the lamp apart, use e.g. one or two flat screwdrivers to remove the glue.

Remove as much of the original glue as possible.

Drill a hole in the lamp where it is marked in the picture. It is an advantage to frame between two heat sinks as this greatly facilitates gluing. Route the light source cable through the hole. Be careful not to damage the jacket. It can be an advantage to lower the gap. It is then important that you close the hole again.

Remove the two outer screws from the original light source and place two spacers on the screw holes. The light source is placed on top of the existing one, with the LEDs off. The light source is screwed on with the two supplied M4x8mm screws. The lamp is glued and screwed together again.

Close the lamp e.g. to the existing position light.