Wiring kit - Lazer - 1 lamp - incl switch - 2 pins - Superseal - 12V

Lazer Cable set 1 lamp (12V)

Cable length 2.2 m
Includes 12V relay and 20A fuse
Superseal connections

The ideal solution for wiring an E-mark approved Lazer high performance LED spotlight. Installation is quick, easy and reliable with a 2-pin superseal connection and no configuration procedures. The kit includes a 12V relay (in waterproof housing), 20A fuse, a battery terminal at one end and 2.2m of cord on the lamp cable, and allows the operation of Lazer products in parallel with the vehicle's standard lighting, and/or via an independent switch that can be mounted in your vehicle.

All Lazer lamps are sold with a pre-wired female connector that attaches to the male connector of the lamp harness, to simplify wiring into your vehicle system.

Compatible with:
ST Evolution (all products)
Triple-R 750 Elite (Gen2)
Triple-R 850 Elite (Gen2)
Triple-R 1000 Elite (Gen2)
Linear-6 (Std/Elite)
Linear-12 (Std/Elite)
Linear-18 (Std/Elite)
Linear-36
Linear-42
Linear-48
Single lamp wiring kit for Lazer E-mark approved driving lights
Cable length 2.2 m
Includes 12V relay and 20A fuse
Superseal connections
Includes optional on/off switch for independent high beam control
Braided cable sections for extra protection in the engine compartment