DENALI 2.0 DataDim Dual Intensity Controller

DENALI 2.0 DataDim dual intensity controller

This DENALI DataDim™ Dual-Intensity Controller allows the DENALI lamps to switch between half and full intensity using your vehicle's original high beam switch. All DENALI 2.0 Light pods are equipped with a special 3rd-wire dimming circuit so that an external signal can reliably control the intensity of the LED chip at the source.

This allows you to (for example) connect your dipped beam to 50% position and your high beam to 100% position.

Please note, if you wish to control the intensity of your lamps separately from the rest of your equipment, you must install the 3-way switch 30500042

What's in the box?
(x1) Dual intensity DataDim™ controller
(x1) Dual intensity trigger wire

Installation Note: Vehicles equipped with LED headlamps may use a ground circuit, which will prevent the DataDim function from being activated with the factory high beam controls. Vehicles with headlights switched to the ground require the DENALI 2.0 DrySeal™ Hi-Low-Off waterproof switch in addition to the DataDim™ to switch between high and low beam.